Adafruit Trinket M0 - Arduino & Circuit Python Compatible

The Adafruit Trinket M0 is a tiny microcontroller board, built around the Atmel ATSAMD21, a little chip with a lot of power. Adafruit have taken the same form factor used for the original ATtiny85-based Trinket and given it an upgrade. The Trinket M0 has swapped out the lightweight ATtiny85 for a ATSAMD21E18 powerhouse. It's just as small, and it's easier to use, so you can do more.

The most exciting part of the Trinket M0 is that while you can use it with the Arduino IDE, it is shipping with CircuitPython on board. When you plug it in, it will show up as a very small disk drive with main.py on it. Edit main.py with your favorite text editor to build your project using Python, the most popular programming language. No installs, IDE or compiler needed, so you can use it on any computer, even ChromeBooks or computers you can't install software on. When you're done, unplug the Trinket M0 and your code will go with you.

Product Video

Quick Spec

• Updating ATtiny85 8-bit AVR for ATSAMD21E18 32-bit Cortex M0+
• 256KB Flash - 32x as much as 8 KB on ATtiny85
• 32 KB RAM - 64x as much as 512 bytes on ATtiny85
• 48 MHz 32 bit processor - 6x as fast as ATtiny85 (not even taking into account 32-bit speedups)
• Native USB supported by every OS - can be used in Arduino or CircuitPython as USB serial console, Keyboard/Mouse HID, even a little disk drive for storing Python scripts. (ATtiny85 does not have native USB)
• Can be used with Arduino IDE or CircuitPython
• Built in red pin #13 LED
• Built in RGB DotStar LED
• All 5 GPIO pins are available and are not shared with USB - so you can use them for whatever you like
• Five GPIO pins with digital input/output with internally connected pullups or pulldowns
• Three of the I/O pins can be used for 12-bit analog input
• True analog output on one I/O pin - can be used to play 10-bit quality audio clips
• Two high speed PWM outputs - for servos, LEDs, etc
• Three pins can also be used as hardware capacitive touch sensors with no additional components required
• Can drive NeoPixels or DotStars on any pins, with enough memory to drive 8000+ pixels. DMA-NeoPixel support on one pin so you can drive pixels without having to spend any processor time on it.
• Native hardware SPI, I2C and Serial available on two pads so you can connect to any I2C or Serial device with true hardware support (no annoying bit-banging). You can have either one SPI device or both I2C and Serial.
• Power with either USB or external output (such as a battery)

Resources

• Product Page
• CircuitPython
• DMA-Driven NeoPixels

Shipping List

• 1 X Trinket M0 - Circuit Python
• 1 X Header Pin