The MSA301 is a super small and low cost triple-axis accelerometer. To make life easier so you can focus on your important work, Adafruit have taken the MSA301 and put it onto a breakout PCB along with support circuitry to let you use the accelerometer with 3.3V (Feather/Raspberry Pi) or 5V (Arduino/ Metro328) logic levels. Additionally since it speaks I2C you can easily connect it up with two wires (plus power and ground). Adafruit have even included SparkFun qwiic compatible STEMMA QT connectors for the I2C bus so you don't even need to solder. Just wire up to your favorite micro and you can use the CircuitPython/Python or Arduino drivers to easily interface with the MSA301 and get motion measurements ASAP.
Three axis sensing, 14-bit resolution
±2g/±4g/±8g/±16g selectable scaling
I2C interface on fixed I2C address 0x26
Multiple data rate options 1 Hz to 500 Hz
As low as 2uA current draw in low power mode (just the chip itself, not including any supporting circuitry)
Triple Axis Accelerometer
Breakout board for the 3 axis ADXL335 from Analog Devices. This is the latest in a long, proven line of analog sensors - the holy grail of accelerometers. The ADXL335 is a t..
MPU6050 3-Axis Acceleration + Gyroscope 6DOF - I2C Interface
The MPU6050 contains both a 3-Axis Gyroscope and a 3-Axis accelerometer allowing measurements of both independently, but all based around ..