BSPT Brass Reducer - 1/8" to 1/4"

This brass reducer allows you to convert between 1/8" BSPT to 1/4" BSPT thread size. Great for reducing the port sizes in valves or other fitting. These fittings are suitable for connecting low carbon steel tube, stainless steel tube, copper pipes, and many types of plastic pipes with size compatible outside diameters. Tighten a minimum of 2-1/2 turns after hand tightening for air tight seal.

Quick Spec

• Material: Brass
• Fitting Direction: Straight
• Fitting Type: Reducer Bush
• Connection 1: 1/8" BSPT Male
• Connection 2: 1/4" BSPT Female
• Max. Pressure: 15 Bar
• Mediums: gas & liquids
• Operating Temperature: -54 ~ +121°C
• Net Weight: 5g

BSP Threads

BSP thread form stands for British Standard Pipe and is common in Australia and the commonwealth countries. It is based on trade size rather than actual diameter which can lead to some confusion when measuring ports.

There are two types of BSP threads;

• BSPP - Female & male thread are both (also known as G)
• BSPT - Female thread is parallel and the male thread is tapered (also know as R/Rp) (the female thread can also be tapered it is then Rc, these are fairly rare to find). Within BSPT it is also common to call the female thread BSPP (parallel) and the male BSPT (tapered) even though they are both technically a BSPT thread form (the female would be parallel and the male would be tapered)

Both threads have the same pitch, angle (55 degrees) and shape (rounded peaks and valleys).

The below table gives the major and minor diameter for each BSP Trade Thread Size. The minor diameter may be ever so slightly smaller than what is in the table depending upon where it has been manufactured to in the thread gauge.

How to Measure Threads

To identify the trade size of the thread, first it must be determined whether the thread is tapered or parallel. This is done by measuring the first, fourth/fifth and last full thread. If the diameter increases from first thread to the last thread on a male thread or decreases from first to last thread on a female thread, then the thread is classified as a tapered thread (such as BSPT). If the diameter stays the same from the first to last thread then the thread is classified as a parallel thread (BSPP).



Once it is known whether the thread is parallel or tapered, it can be measured to determine it’s trade size. This trade size will not directly represent what is measured, ie. ½" BSP does not equal ½” measured.

For a parallel thread, any thread can be used to measure for its trade size, and for a tapered thread the fourth or fifth full thread is used. This measurement can then be referenced against a thread table to match it to its trade size.

Shipping List

• 1 x BSPT Brass Reducer - 1/8" to 1/4"