PYCOM FiPy - LoRa Sigfox LTE

Imagine 5 networks in one perfectly-formed, same-small-foot-print-as-WiPy- LoPy-and SiPy, IoT development board. MicroPython enabled. FiPy includes WiFi, Bluetooth, LoRa, Sigfox and dual LTE-M (CAT M1 and NBIoT) the FiPy gives access to all the world’s LPWAN networks on one tiny board.
Get on with a board that gives you full flexibility during testing, install, deployment and even later when you want to switch real-time your airtime network provider. You can switch when the time is right for you or set some parameters that will do so automatically.

Note: The LTE Antenna MUST always be used with LTE CAT M1 / NB1, or it could cause serious damage to the development board.

Quick Spec

  • Powerful CPU
  • Five networks: WiFi, BLE, cellular LTE-CAT M1/NB1, LoRa and Sigfox
  • 1KM WiFi range
  • MicroPython enabled
  • Fits in a standard breadboard (with headers)
  • Ultra-low power usage: a fraction compared to other connected microcontrollers
  • Processing
    • Espressif ESP32 SoC
    • Dual processor and WiFi radio system on chip
    • Networking processor handles the WiFi connectivity and the IPv6 stack
    • Main processor is entirely free to run the user application
    • An extra ULP-coprocessor that can monitor GPIOs, the ADC channels and control most of the internal peripherals during deep-sleep mode while only consuming 25uA
  • Interfaces
    • 2 x UART, 2 x SPI, I2C, micro SD card
    • Analog channels: 8×12 bit ADCs, 2×8 bit DAC
    • Timers: 2×64 bit with PWM with up to 16 channels
    • DMA on all peripherals
    • GPIO: Up to 22
  • Hash / Encryption: SHA, MD5, DES, AES
  • WiFi Networking: 802.11b/b/n 16mbps
  • Bluetooth: Low energy and classic
  • RTC: Running at 32KHz
  • Range: Node range: Up to 50km
  • Security & Certifications
    • SSL/TLS support up to 1.2
    • WPA Enterprise security
    • AES encryption engine
  • Memory
    • RAM: 4MB
    • Flash Memory: 8MB
    • GPIO: Up to 22
    • Hardware floating point acceleration
    • Python multi-threading
  • Power
    • Voltage Input: 3.3V – 5.5V
    • 3v3 output capable of sourcing up to 400mA
  • Sigfox Operating Frequencies
    • RCZ1 – 868MHz(Europe)
    • RCZ2 – 902MHz (US, Canada and Mexico)
    • RCZ3 – (Japan and Korea)
    • RCZ4 – 920-922MHz (ANZ, Latin America and S-E Asia)
  • Sigfox Specification
    • TI CC1125NarrowbandTransceiver
    • Class 0 device. Maximum Tx power:
      • +14dBm (Europe)
      • +22dBm (America)
      • +22dBm (Australia and New Zealand)
    • Node range: Up to 50km
    • Sigfox pre-certified (October 2016)
  • Power
    • Sigfox (Europe): 17mA in Rx mode, 47mA in Tx mode and 0.5uA in standby
    • Sigfox (Australia, New Zealand and South America): 24mA in rX mode, 257 mA in Tx mode and 0.5uA in standby
  • Bluetooth Networking
    • Low energy and classic
    • Compliant with Bluetooth v4.2 BR/EDR and BLE specification
    • Class-1, Class-2 and Class-3 transmitter without external power amplifer
    • Enhanced power control
    • +10dBm transmitting power
    • NZIF receiver with -98 dBm sensitivity
    • Adaptive Frequency Hopping (AFH)
    • Standard HCI based on SDIO/SPI/UART
    • High speed UART HCI, up to 4 Mbps
    • BT 4.2 controller and host stack
    • Service Discover Protocol (SDP)
    • General Access Profile (GAP)
    • Security Manage Protocol (SMP)
    • Bluetooth Low Energy (BLE)
    • ATT/GATT
    • HID
    • All GATT-based profile supported
    • SPP-Like GATT-based profile
    • BLE Beacon
    • A2DP/AVRCP/SPP, HSP/HFP, RFCOMM
    • CVSD and SBC for audio codec
    • Bluetooth Piconet and Scatternet
  • LoRa Operating Frequencies
  • 868MHz(Europe) at +14dBm maximum
  • 915MHz (North and South America, Australia and New Zealand) at +20dBm maximum
  • LoRa Specification
    • Power consumption: 10mA Rx, 28mA Tx
    • LoRaWAN stack – Class A and C devices
    • Node range: Up to 40km
    • Nano-gateway: Up to 22km (Capacity up to 100 nodes)
  • LTE-M Operating Frequencies
    • 34 bands supports from 699Mhz to 2170Mhz (Total world-wide support)
  • LTE-M Specification
    • One single chip for both CAT M1 and NB1 (yes, only one chip)
    • 3GPP release 13 LTE Advanced Pro
    • Supports narrowband LTE UE categories M1/NB1
    • Integrated baseband, RF, RAM memory and power management
    • Reduced Tx power class option
    • Peak power estimations: TX current = 420mA peak @1.5Watt RX current = 330mA peak @1.2Watt
    • Data rates:
      • 300 kbps DL
      • 375 kbps UL (LTE Cat M1 in 1.4 Mhz, HD-FDD)
      • 40 kbps DL
      • 55 kbps UL (LTE Cat M2 in 200 kHz, HD-FDD)
  • Tx/Rx Frequencies
    • Tx frequencies
      • Low bands 5, 8, 12, 13, 18, 19, 20, 28: 699 to 915 MHz
      • Mid bands 1, 2, 3, 4: 729 to 960 MHz
    • Rx frequencies
      • Low bands 5, 8, 12, 13, 18, 19, 20, 28: 1710 to 1980MHz
      • Mid bands 1, 2, 3, 4: 1805 to 2170 MHz
  • WiFi Networking
    • Up to 1km range
    • 802.11b/g/n 16mbps
    • Power: 12mA in active mode, 5uA in standby
  • Size: 55m x 20mm x 3.5mm

Resources

Shipping List

  • 1 x PYCOM FiPy - LoRa Sigfox LTE


PYCOM FiPy - LoRa Sigfox LTE

  • Brand: Pycom
  • Product Code: PYC-FIPY
  • Stock

    Warehouse Stock Status Location
    Centurion Out Of Stock UR250
    Stellenbosch Out Of Stock
  • R995.00 (Inc Tax: R1,144.25)


Related Products

Adeunis Sigfox Signal Tester 868Mhz - End of Line

Adeunis Sigfox Signal Tester 868Mhz - End of Line

Adeunis Sigfox Signal Tester 868Mhz END OF LINE Please note, this product has been retired and is no longer available. The Field Test Device (FTD) from Adeunis is a Class A LoRaWAN compatible..

R4,385.00 (Inc Tax: R5,042.75)

PYSCAN + RFID-NFC + Accel + Antenna

PYSCAN + RFID-NFC + Accel + Antenna

PYSCAN + RFID-NFC + Accel + Antenna Pyscan is a sensor shield you can use with any of your Pycom multi-network development boards! Featuring an accelerometer, ambient light sensor and NFC/RFID antenn..

R825.00 (Inc Tax: R948.75)

Wave LoRa SX1268 433MHz for Pi

Wave LoRa SX1268 433MHz for Pi

Wave LoRa SX1268 433MHz for Pi This is a Raspberry Pi LoRa HAT based on SX1268, covers 433MHz frequency band. It allows data transmission up to 5km through serial port. By utilizing the new generatio..

R298.00 (Inc Tax: R342.70)

Wave LoRa SX1262 868MHz for Pi

Wave LoRa SX1262 868MHz for Pi

Wave LoRa SX1262 868MHz for Pi This is a Raspberry Pi LoRa HAT based on SX1262, covers 868MHz frequency band. It allows data transmission up to 5km through serial port. By utilizing the new generatio..

R335.00 (Inc Tax: R385.25)

Crow PyBoard + Shield

Crow PyBoard + Shield

Crow PyBoard + Shield The Crow Pyboard is a powerful electronics development board which runs MicroPython. Connecting it to your PC via USB, and giving you a USB flash drive on which to save your Pyt..

R348.00 (Inc Tax: R400.20)

Tags: PYCOM, FiPy, LoRa, Sigfox, LTE, IoT, Wifi, Bluetooth, LTE-M, dual