The AD8318 is a demodulating logarithmic amplifier, capable of accurately converting an RF input signal to a corresponding decibel-scaled output voltage. The device is used in measurement or controller mode. The AD8318 maintains accurate log conformance for signals of 1 MHz to 6 GHz and provides useful operation to 8 GHz. The input range is typically 60 dB (referenced to 50 Ω) with error less than ±1 dB. The AD8318 has a 10 ns response time that enables RF burst detection to beyond 45 MHz. The device provides unprecedented logarithmic intercept stability vs. ambient temperature conditions.
Quick Spec
Operating frequency: 1-8000MHz
Dynamic Range: -65dBm to + 5dBm
Detection slope: -25 mV / dB (Typical values)
Detection output voltage range: 0.5--2.1V
Power supply voltage: 7-15VDC (containing the power regulator circuit)
RF Digital Attenuator 6GHz +Display
The RF Digital Attenuator is an electrical component that reduces the amplitude of a signal passing through it without significantly degrading the integrity of t..
RF Attenuator Module
The PE4302 is a numerical control RF attenuator module which offers a wide range of amazing performance. It provides 31.5 dB attenuation range in 0.5 dB steps, 50 ohm impedance..
RF Amplifier 6GHz 20DB 5V
This is a 5-6000MHz RF signal power amplifier with 20dB gain. It has wide dynamic range and wide operating frequency range. The module uses a 5V power supply and a working..
RF Splitter DC to 5GHz Module
The RF Power Divider/Splitter is a passive RF device that splits an input signal into two output signals with minimal losses. RF power splitters are widely used in wir..
Clock Generator Module - 8KHz to 160MHz
The SI5351 chip has a precision 25MHz crystal reference and internal PLL and dividers so it can generate just about any frequency, from 8KHz up to 150+ MHz.
..