This plug-n-play pot comes with a JST-PH 2mm connector and a matching JST PH 3-Pin to Male Header Cables - 200mm, so wiring up is very simple. Simply plug the cable in, then use the black wire to connect to your ground, white wire to the input/signal pin and the red wire to your power pin. The power pin voltage should match the voltage max of your analog input. So, if you're using a 5V Arduino or compatible, connect red to 5V.
10K Potentiometer Module
An adjustable potentiometer can open up many interesting user interfaces. Turn the pot and the resistance changes. Connect VCC to an outer pin, GND to the other, and the cent..
Analog Slider Module
The Slide potentiometer (analog) is a variable resistor for 10KOhm. The potentiometer can be slide to provide a varying voltage that your microcontroller can read using an analog..