The Molex GNSS Flex antenna is a great option for basic GNSS applications and will work with any of the GNSS boards equipped with a U.FL at a fraction of the cost of many of its big brothers. This antenna supports GPS, Galileo, BeiDou, and GLONASS in three different frequency bands (1561 +/-3MHz, 1575 +/-3MHz, 1602 +/-3MHz).
The Molex Flexible GNSS Antenna has an incredibly small footprint at 40.40mm x 15.40mm, while the adhesive pad is a bit bigger at 56.40mm x 20mm. Even better, the antenna is only 0.1mm thick (or about the thickness of a piece of paper). Simply remove the backing and stick this to any surface, or leave the backing on (just be careful of the fragile U.FL connector).
SparkFun GPS Breakout - XA1110 (Qwiic)
The SparkFun XA1110 GPS Breakout is a small I2C-supported module built for easy hookup, thanks to SparkFun's Qwiic Connect System. Equipped with the XA1110 GPS ..
SparkFun GPS Breakout - Chip Antenna
The SparkFun SAM-M8Q GPS Breakout is a high quality, GPS board with equally impressive configuration options. The SAM-M8Q is a 72-channel GNSS receiver, meaning i..
SparkFun GNSS Chip Antenna Eval Board
What is the best chip antenna for your GNSS project? There are tons to choose from, but finding the right one might be tricky so here's a board that helps make d..
Desoldering Braid (2 Pack)
Our thin and soft desoldering wire’s flat braid has efficient thermal transmission. It removes solder faster with better heat response than previous wicks. It is recommende..
Solder 0.8mm 250g
Flux Core Solder Wire is a tin based solder, manufactured in accordance with SABS 0157 requirements from only virgin raw materials to meet most international specifications. Therefo..