2.13 inch E-ink Display HAT for Pi

This is a flexible E-Ink display HAT for Raspberry Pi, 2.13inch, 212x104 resolution, with embedded controller, communicating via SPI interface, supports partial refresh. Compared with normal e-Paper panels, this flexible panel allows bending without being damaged, and it's thinner and lighter.
Combined with the advantages like ultra low power consumption, wide viewing angle, clear display without electricity, it is an ideal choice for applications where curved surface display is required, such as industrial instruments, smart wearable-devices, and so on.

Quick Spec

• No backlight, keeps displaying last content for a long time even when power down
• Ultra low power consumption, basically power is only required for refreshing
• Compatible with Raspberry Pi Zero/Zero W/Zero WH/2B/3B/3B+
• Preserved solder pads for SPI interface, for connecting with other controller boards like Arduino/Nucleo, etc.
• Comes with development resources and manual (examples for Raspberry Pi/Arduino/STM32)
• Specifications
• Operating voltage: 3.3V
• Interface: 3-wire SPI, 4-wire SPI
• Outline dimension: 59.2mm × 29.2mm × 0.3mm
• Display size: 23.71mm × 48.55mm
• Dot pitch: 0.229 × 0.228
• Resolution: 212 × 104
• Display color: black, white
• Grey level: 2
• Full refresh time: 2s
• Refresh power: 26.4mW(typ.)
• Standby power: <0.017mW
• Viewing angle: >170°

Pin Layout

• VCC: 3.3V / 5V
• GND: Ground
• NC: NC
• DIN: SPI MOSI pin
• CLK: SPI SCK pin
• CS: SPI chip selection, low active
• DC: Data/Command selection (high for data, low for command)
• RST: External reset, low active
• BUSY: Busy status output, low active

Dimensions

Resources

• Product Page
• Product Wiki

Shipping List

• 1 x 2.13inch e-Paper (D)
• 1 x e-Paper Driver HAT
• 1 x RPi screws pack (2pcs)
• 1 x PH2.0 20cm 8Pin