ZD-985 Desoldering Station 80W

This temperature controlled desoldering station makes desoldering of through-hole parts a breeze. Simply place the heated tip of the gun over the pin to be de-soldered, wait for the solder to melt, then press the trigger. This will activate the vacuum pump in the station to suck the melted solder through the hollow tip into a waste reservoir and leave the component's leg and PCB free of solder. It only takes a few seconds per pin.

If you've ever tried to de-solder parts using wick or a manual vacuum pump, you know how difficult that is, particularly on a double-sided board. You will NOT have these problems using our desoldering station, because it sucks the solder from both sides of the board, leaving the hole and component leg virtually free of solder.

The station has a dual LCD display, showing the desired temperature and the actual temperature. The display can be switched from Fahrenheit to Celsius if, and the desired temperature can be dialed-in using the up/down buttons. An illuminated power on/off switch is also located on the front.

The side of the station features a typical holder, with sponge. Two lines (power and vacuum, both can be disconnected) connect the station to the gun. There is a filter at the station-side of the vacuum connector, and another filter in the gun itself.

Quick Spec

• Model: ZD-985
• Power: 80 Watt
• Temperature Range: 160 - 400°C
• Heating Element: Ceramic
• Vacuum Pressure: 600 mm Hg
• Dimensions: 18 x 16 x 16cm (only base)

Disclaimer: Please note that the ZD-985 Desoldering Station 80W is designed for efficient use within a temperature range of up to 400°C. Extended operation at maximum temperature may cause damage to the unit. To prevent overheating and ensure the device's longevity, avoid prolonged usage at the highest temperature setting.

Shipping List

• 1 x Temperature Controlled Station, with AC Power Cord (ZD-985)
• 1 x Vacuum Desoldering Gun (80-552B)
• 3 x tips with different sized holes (0.8mm = N5-2, 1mm = N5-1, 1.3mm = N5-3)
• 3 x cleaning rods (these are used to clean the hole in the tips when necessary)
• 2 x Spare Filters
• 1 x AC Cord