PWM to 0-10V 0-5V Converter Module

The PWM to 0-10V 0-5V Converter Module accepts 4-24VDC amplitude 5Hz-500Hz or 50Hz-10kHz PWM signal input and converts it into proportional standard DC voltage output. The PWM signal is processed by the internal linear regulation and conversion circuit and chips. It is in high linearity, high efficiency, small size and low cost. The output is standard 0-5VDC or 0-10VDC, which can be switched by creating a short on the S2 solder pads. This PWM to voltage signal converter module is widely used in remote data acquisition and controlling devices, transmitter, DAC based circuits, meters and instruments, etc. This pulse width modulation module provide a low cost simple solution in developing a controlling system based on PWM.

Quick Spec

• Input Signal: PWM Signal
• Input Amplitude: 4-24VDC
• Frequency Range: 5Hz- 500Hz OR 50Hz～10KHz
• Duty Ratio: 0～100%
• Input Mode: S1 soldering pad: the default is open circuit, no function
• Output Signal: 0-5VDC or 0-10VDC
• Output Load Capacity: ±10mA
• Output Selection: S2 soldering pad: the default state is open circuit 0-5VDC output.
  If 0-10VDC output is required, the S2 soldering pad should be in short-circui
• Output Accuracy (output resolution)
• 0-5VDC output: 0.050V/D (V/Duty ratio)
• 0-10VDC output: 0.100V/D (V/Duty ratio)
• Power Supply: 9-24VDC
• Jointing Temperature (10sec.): +300℃
• Operating Temperature: -20 ~ +70℃
• Operating Humidity: 0–90% RO
• Storage Temperature: 20 ~ +75℃
• Storage Humidity: 0–95% RO
• Pin Spacing: 2.54mm
• Dimensions: 26 x 23 x 10mm

Pinout

• 12V: Power Supply +
• G: Power Supply Ground
• IN: Signal Input +
• G: Signal Input -
• OUT: Signal Output +
• G: Signal Output -

Output voltage (V)/Output resolution=Duty Ratio (%)
Note: when the output is 0-10VDC, the power supply voltage must be ≥15VDC

Shipping List

• 1 x PWM to 0-10V 0-5V Converter Module