The SparkFun Qwiic pHAT for Raspberry Pi (based on the original Qwiic Hat) provides you with the quickest and easiest way to enter into SparkFun’s Qwiic ecosystem while still using that Raspberry Pi that you’ve come to know and love. The Qwiic pHAT connects the I2C bus (GND, 3.3V, SDA and SCL) on your Raspberry Pi to an array of Qwiic connectors on the HAT. Since the Qwiic system allows for daisy chaining boards with different addresses, you can stack as many sensors as you’d like to create a tower of sensing power!
The Qwiic pHAT has four Qwiic connect ports, all on the same I2C bus. This HAT is compatible with any Raspberry Pi that utilizes the standard 2x20 GPIO header. It is also compatible with the NVIDIA Jetson Nano as well as the Google Coral.
Qwiic Starter Kit
The Qwiic Starter Kit was designed to allow users to get started with Arduino without the need for soldering or breadboarding. Hooking up a handful of inputs and outputs to an Ardui..
Qwiic SparkFun VR IMU Breakout - BNO080
The Qwiic SparkFun VR IMU Breakout is powered by Bosch’s BNO080, a combination triple-axis accelerometer/gyro/magnetometer SiP, packaged with a 32-bit ARM Cort..
Qwiic SparkFun Distance Sensor
This SparkFun Distance Sensor Breakout utilizes the VL53L1X next generation ToF (Time of Flight) sensor module to give you the highly accurate measurements at long rang..
SparkFun Pi Wedge
This is the SparkFun Pi Wedge, a small board that connects to the 40-pin GPIO connector on the Raspberry Pi and breaks the pins out to breadboard-friendly arrangement and spacing, a..
SparkFun GPS Breakout - XA1110 (Qwiic)
The SparkFun XA1110 GPS Breakout is a small I2C-supported module built for easy hookup, thanks to SparkFun's Qwiic Connect System. Equipped with the XA1110 GPS ..
Qwiic MUX Breakout - 8 Channel TCA9548A
The Qwiic Mux Breakout enables communication with multiple I2C devices that have the same address that makes it simple to interface with. The Qwiic Mux also ha..