SHT10 Temperature + Humidity Sensor - 5m

The precision SH10 series temperature and humidity sensors form Sensirion are individually calibrated in a precision humidity chamber and the calibration coefficients are stored on the sensor chip. The SHT1X sensors use a 2-wire serial interface and internal voltage regulation and this allows for easy and fast system integration. The tiny size and low power consumption makes SHT1x series a good choice for even the most demanding applications. The casing is weatherproof and will keep water from seeping into the body of the sensor and damaging it, but allows air to pass through so that it can measure the humidity outside. Humidity readings have 4.5% precision, temperature is 0.5% precision.

Quick Spec

• Sensor: Digital SHT10 High Precision Sensor
• Supply: 3.3 - 5V
• Calibration: Factory - Calibration coefficients are programmed into an OTP memory on the chip
• Low power consumption: 0.15mW
• Probe : Factory fitted with 10k pull-up resistor and filter capacitor 0.1uf
• Interface Type: Serial Digital Two-Wire
  
• Humidity Ranger: 0-100%RH
• Temperature ranger: -10-80℃
• Humidity accuracy:±5.0%RH
• Temperature accuracy:±0.5℃
• Size: 49mm x 14mm
• Cable Length: 5 m

Pin Config - Colour Coding

Please note- There is no industry standard for colour coding of sensor wires, see image on top for popular wiring options in the industry. The current probe we have in stock is wired as follows.

• Brown = Vcc - 5V
• Black = GND
• Yellow = Data
• Blue = Clock

Decoupling

Power supply pins (VCC, GND) must be decoupled with a 100nF capacitor. Don't forget to connect a 10K resistor from the blue Data line to VCC. Like in our case, some probes come pre fitted with the decoupling capacitor and pull-up resistor.

Resources

• Arduino SHT1X series Library - Github
• SHT1X Series datasheet

Sample Code

Shipping List

• 1 x SHT10 Temperature + Humidity Sensor - 5m