This current-to-voltage module can linearly convert 0~25mA current signals into 0~3V voltage signals. Industrial sensors or devices usually have the current signal output of 4~20 mA. With this current-to-voltage module, your main control board can easily attain the current signals input from industrial sensors or devices.
Normally, current signals lower than 4mA can be used for fault diagnosis, and current signals higher than 20mA can be used for overrun detection. Therefore, this module is specially designed with a wide detection range from 0 to 25mA, and compatible with fault detection, overrun detection applications.
This module employs 0.1% high precision sense resistor and ultra-low noise rail-to-rail zero-drift op amp, high accuracy, no need to calibration, so it is convenient to use. 3.3V~5.5V wide voltage power supply, 0~3V voltage signal output, which are compatible with more main control boards, adapt to more applications.
NOTE: For higher accuracy, it is recommended to measure with 12 or more bit ADC!
Signal Convert In 0-5K Out 0-5V
The SC09 is a potentiometer resistance to voltage linear transformation transmitter remote data acquisition module. The board takes 0-5000 Ohm and gives a 0-5V/0-10V o..
Signal Convert In = PT100 Out = 0-5V
This is a linear conversion module with cold junction compensation. The chip converts the input thermocouple signal into temperature (voltage signal) output throu..